How do you override Drayton Digistat?

When in Auto mode you can override the existing temperature setting by pressing + or -. During adjustment the temperature will flash then stop. The Digistat+3 will now control at this temperature until the next programmed time/temperature event is reached, when the Digistat+3 will revert back to Auto mode.

How do I reset my Drayton programmer?

If the programmer is in the Service mode, i.e.SEr permanently displayed then you will have to reset the programmer by positioning the reset unit as shown below and pressing the button before the service interval menu can be accessed. Remove the screw on the bottom of the unit and take off the back cover.

What does hot water Advance mean?

The Advance button for each, will advance the programmed setting to the next on/off position. So if you want an early night and your heating is not programmed to go off until after you’ve gone to bed, pressing the Advance button will advance to the off position.

How do I reset my Drayton receiver?

Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds.

How do I reset my Drayton control panel?

Press the raised button once, the programmers counter will now be reset and the display should now show, The Con should not flash. This will remain for approx 10 seconds, and then the programmer will return to normal function, and the service settings will be set.

What is the best temperature to set your boiler?

As a rule, setting your heating control to 75 degrees should be sufficient to give you a perfectly warm house, while also allowing your boiler to run as economically as possible. Once this is set, you shouldn’t need to adjust it.

What is a good hot water schedule?

Try an hour in the morning and an hour in the evening – if you don’t run out of hot water, that’s enough!

How do I reset my Drayton Digistat?

Reset If at any time during the programming you get confused and would like to start the procedure from the beginning press the SELECT and – buttons at the same time and hold for two seconds. This resets the Digistat to the factory preset times and temperatures shown in the table (overleaf).

How do I reset my Drayton Digistat RF?

To do this, remove the batteries, press and hold the ‘set’ button whilst refitting the batteries, keep the ‘set’ button held and after a few seconds the display will show ‘rF’ which indicates that the Digistat+RF is continuously sending an OFF signal to the SCR (receiver).

How do you reset a Drayton thermostat?

What temperature should a hot water boiler be set at?

The best temperature for your hot water cylinder is between 140-150 degrees Fahrenheit. For health and safety reasons, try to keep your boiler water temperature from getting too low. A bacteria called Legionella can grow in freshwater with a temperature of 77-112 degrees Fahrenheit.

Why is my thermostat not connecting to my boiler?

Check the batteries in the thermostat It sounds so obvious but this is a really common thing. Being wireless, the sole power source for the thermostat is its batteries and they don’t last forever. Try changing the batteries and then turn the heating on.