Tips and tricks

How do you install wire shelving clips?

How do you install wire shelving clips?

The quickest and most secure way to install wire shelving is to draw a straight, level line on the wall where you want the shelves to hang. Next, drill holes along the marked line every 12 inches and install your shelf clips. After this, install end brackets and put your shelves into place.

How do you join two shelves together?

Use 4-inch long brackets approximately ¾ inch in width. Evenly space the brackets across the bottom seam where the shelves intersect. Use at least two screws in the brackets on each side of the seam. This should provide enough support.

How far apart should wire shelf brackets be?

For light to medium loads, shelving brackets should be spaced no more than 24 inches apart. For longer wire shelving, attach a bracket at least every 48 inches. For heavier loads, increase the size of your brackets and decrease the space between them.

How to install wall mounted Wire shelving?

Find the wall studs using a stud finder.

  • Plan to fasten your brackets through the tile and into the wall studs.
  • Pre-drill holes through the masking tape X’s using a masonry drill bit.
  • Start drilling at an angle until you make an indent in the tile.
  • Check and recheck the level of the holes as you go.
  • Remove the masking tape.
  • How to best use Wire shelving?

    – Absorbs moisture – Edges don’t fray – Made with recycled materials

    What do you need to know about Wire shelving?

    1 inch between locator rings

  • 2.5 inches from bottom of post to first set of double rings
  • Leveling foot has 12 threads per inch thread-count
  • Threaded area is .5 inches thick
  • How do I install shelving?

    Take a look at What’s Inside My Wall?

  • Locating studs is very important because drywall is too weak to hang things from.
  • If you must hang something from the drywall,you can use drywall anchors.
  • A pocket hole is an angled hole drilled into a board to hide screws in your project.