Where can you use FireLine plasterboard?

Gyproc FireLine 12.5mm is a fire resistant plasterboard that withstands fire for longer to allow for safe evacuation. The board’s excellent fire resistance rating makes it ideal for lining walls and ceilings in commercial spaces like offices and shopping centres, as well as in low rise housing and new build garages.

Will B&Q cut plasterboard?

Our saws operational capabilities and limitations The saw cannot cut doors, fence panels and lattices, plasterboard and mineral based boards, strip timber and thick structural timber. We can cut panels that have the following minimum and maximum dimensions: Minimum panel length – 500mm.

What is the fire rating of 15mm FireLine board?

This 15mm fireboard plasterboard is one of the products within our plasterboard range that is certified to BES 6001 achieving a rating of ‘Very Good’.

How many plasterboards are on a pallet?

5MM TE STANDARD (80 PER PALLET)

Can you skim FireLine board?

Gyproc FireLine is a plasterboard that is suitable for drylining internal surfaces which can be skim plaster finished or directly decorated. Plasterboard linings provide good fire protection owing to the unique behaviour of the non-combustible gypsum core when subjected to high temperatures.

What is 9.5 mm plasterboard used for?

The most common plasterboard thickness is 9.5mm and 12.5mm. For ceilings is used 9.5mm thick plasterboard and for walls – 12.5mm.

Do I need to use fire rated plasterboard?

If the ceiling is plasterboarded, then 12.5mm thick boards are required to give 30 minutes’ fire resistance. You may have to provide an additional skim coat or additional plasterboard to the ceiling.

How much does a pallet of 12.5 mm plasterboard weight?

Pallet of Plasterboard 2400 x 1200 x 12.5mm (8′ x 4′ x 1/2″) 72 Sheets.

Weight	1700 kg
Edge	Tapered Edge, Square Edge

How many sheets of 15mm plasterboard are on a pallet?

15mm Knauf Plasterboard | Wall Board | Pallet of 60.

Does 2 layers of plasterboard fire rating?

Two layers of standard plasterboard with staggered joints will give an hours protection and one layer half an hour.

How do you cut fireproof plasterboard?

Use a pencil to mark where the plasterboard needs to be cut. The light grey side should face outwards, with any writing on the back. For straight cuts, use your straight edge as a guide, then slice along the paper and into the core with your Stanley knife.

Is 9.5 mm plasterboard OK for ceilings?

Standard plasterboard thicknesses for ceilings are usually 9.5 mm to 12.5 mm, while walls can be 12.5 mm to 15 mm.

Is it OK to paint directly onto plasterboard?

Painting Plasterboard is Perfectly Fine Painting straight onto/over plasterboard is simple and easy once you have covered the joints and any fixings with joint filler.

How many meters is 8×4 plasterboard?

An 8×4 sheet is approx 3sq mts, you can work the rest out, allow a bit for waste.