Are spot bots worth it?

It’s a nifty little device that makes cleaning spots easy so you don’t have to pull out any large equipment. It’s easy to setup, use, clean, and then store away. The SpotBot is a little on the expensive side (seeing as how you can buy full sized carpet cleaners for $25-$50 more) but it’s worth it for the convenience.

How does the SpotBot work?

BISSELL SpotBot Pet has preset cleaning cycles that automatically spray, brush, and remove both surface and tough pet stains and odors. Place filled clean water solution tank onto the unit. Plug in your SpotBot, the power light will indicate the machine is ready.

Can you use Spot Bot on tile?

No. For the vacuum to get the right suction off a hard surface the tip of the nozzle will need rubber lips to get the right seal. This only has a hard plastic tip meant to work in carpet only.

How do you set up a Spotbot?

SPOTBOT Installation Manual

1. Connect the supplied 5V-4A power supply to the DC plug of the SPOTBOT.
2. Plug the supplied USB SOUND CARD into any USB port on the SPOTBOT.
3. Connect the SPOTBOT to the same Local Area Network (LAN) that the CCTV camera system is connected to, using the supplied LAN cable.

What kind of soap can I use in my Bissell carpet cleaner?

To make a carpet shampoo used by many Bissell owners, mix the following: a half cup of laundry detergent (no bleach), a half cup of liquid laundry softener, one cup of ammonia and one gallon of water.

Can I use my Bissell carpet cleaner on wood floors?

Steam it to clean it Steaming is safe on virtually all sealed hard surfaces including vinyl, laminate, ceramic, granite, marble and sealed hard wood.

How do you deep clean a Bissell Spotbot?

To remove the tank, lift up the dirty tank latch and pull the tank out. Dump out the dirty water and rinse out the tank. Dump out any remaining water/solution from the clean tank and rinse out before storing. Re-place the tank in the unit.

Why is my Bissell Spot cleaner not picking up water?

Clogged Automatic Cleaner Unplug device, remove tanks and flip it over. Check the clear plastic floor nozzles for debris. If they are dirty, unscrew the two screws next to them to remove the nozzle and clean with warm water. Check the suction holes where the nozzles were for any debris and clean them out.

Is Dawn dish soap a good carpet cleaner?

Dawn liquid dish soap effectively cuts through grease, making it suitable for removing greasy carpet stains. Protein stains on your carpet, such as cat urine or spilled milk, pose a cleaning challenge. Use a cleaning product containing enzymes, such as Dawn Plus, to tackle protein stains.